Type “F” Cup Testers

Type “F” Cup Testers

F CUP TESTER 4 Type F Cup TestersIngram International, Inc. “F” type cup tester assemblies are designed to be attached to the drill string and then lowered into the casing beneath the wellhead to pressure test the blowout preventer stack and the wellhead.  When the F type cup tester is lowered into the casing beneath the wellhead, pressure is applied to either a test pump, or by hoisting the “F” type cup after filling the hookup with water. The latter method is fast and accurate.

The cup tester assemblies are rated to the API standard mill test pressure for casing sizes up to 10,000 psi. Special reinforcing can be offered on all cup sizes and casing weight ranges to hold up to 15,000 psi. Ingram International, Inc. has the sizes, pressure ratings and connections for every single one of your jobs.

Ingram International, Inc. cup tester assemblies come standard with internal flush (IF) connections. Other connections are available at an additional cost. When ordering please specify (1) the casing size & weight per foot or (2) the part number or (3) the OD, ID, and drift diameter. Anytime the “F” type cup tester is used; care should be taken to ensure that the drill pipes load capacity is not exceeded. This can be checked by adding the weight of the suspended pipe to the vertical load due to pressure. To find this multiply the cup pressure area (IN.²) by the pressure. The table below shows the total load capacity for each size tester.


TABLE CUP TESTER1 Type F Cup Testers

TABLE CUP TESTER2 Type F Cup Testers

Download F Cup Tester Information